arrow_left

How to make a 2D origami boot of Santa Claus

(page 1)

 arrow_right

 

2D origami boot of Santa Claus

 

Level Beginner
Copyright Traditional

This page is for those who want the instruction to fold a 2D origami boot of Santa Claus.

 

This 2D origami boot of Santa Claus is an easy origami model to fold. Although this is 2D model, you can make it stand on the ground. One special folding technique involved with this model is inside reverse-fold.

 

Before working on this model, you need to know what valley-fold and mountain-fold are. If you know these two folding techniques, then you will have no problem in making origami boot.

 

If you are ready, then let's get started.

 

If you find any bugs on this instruction, please send an email to HyoAhn's email.

 

You may use any kind of paper to fold this origami boot. Here I am using a typical origami paper with 15cm x 15cm square.

2D origami boot of Santa Claus: front side of paper

00A.

This is the front side of paper.

 

15cm x 15cm square paper is being used here.

2D origami boot of Santa Claus: back side of paper

00B.

This is the back side of paper.

 

Share this page through
Twitter Facebook MySpace Digg Digg Digg
Digg Digg Digg Digg Digg Digg

 

left arrow
left arrow

 

1 2 3 4 5 6 7 8 9 10

 

 




Boot



You wish you could get the whole enchilada
To rule over the world and be the firstest with the mostest.
Being a mortal, all you can take with you is nada,
Your chance of having an eternal life is the fattest.
Before buying it, you'll behold the angel of death
And your disbelief in magic may scare the hell out of you.
It's too painful to part forever with your untold wealth,
Your life rewinds like a rapid flick, and you freak anew.
Unable to let it ride, you appeal to the grim messenger
For divine mercy, unwilling to take the obscure route.
You hear him say, ''You're my late-night transit passenger,
Once you arrive at your destination, you'll get a real boot.''



Poem by Aram Stefanian



Let's share the photo of "2D origami boot of Santa Claus" you made by submitting it below:
Please do not write here if you want to contact Hyo Ahn. Send an email to HyoAhn email instead.
A Comment without a relevant photo submitted will be removed immediately.
blog comments powered by Disqus


How To Make A 2D Origami Boot Of Santa Claus


© 2010-2011 origami-make.com All Rights Reserved